Полезная информация

Perl Cookbook

Perl CookbookSearch this book
Previous: 3.1. Finding Today's DateChapter 3
Dates and Times
Next: 3.3. Converting Epoch Seconds to DMYHMS

3.2. Converting DMYHMS to Epoch Seconds


You want to convert a date, a time, or both with distinct values for day, month, year, etc. to Epoch seconds.


Use the timelocal or timegm functions in the standard Time::Local module, depending on whether the date and time is in the current time zone or in UTC.

use Time::Local;
$TIME = timelocal($sec, $min, $hours, $mday, $mon, $year);
$TIME = timegm($sec, $min, $hours, $mday, $mon, $year);


The built-in function localtime converts an Epoch seconds value to distinct DMYHMS values; the timelocal subroutine from the standard Time::Local module converts distinct DMYHMS values to an Epoch seconds value. Here's an example that shows how to find Epoch seconds for a time in the current day. It gets the day, month, and year values from localtime:

# $hours, $minutes, and $seconds represent a time today,
# in the current time zone
use Time::Local;
$time = timelocal($seconds, $minutes, $hours, (localtime)[3,4,5]);

If you're passing month and year values to timelocal, it expects values with the same range as those which localtime returns. Namely, months start at 0, and years have 1900 subtracted from them.

The timelocal function assumes the DMYHMS values represent a time in the current time zone. Time::Local also exports a timegm subroutine that assumes the DMYHMS values represent a time in the GMT time zone. Unfortunately, there is no convenient way to convert from a time zone other than the current local time zone or GMT. The best you can do is convert to GMT and add or subtract the time zone offset in seconds.

This code illustrates both the use of timegm and how to adjust the ranges of months and years:

# $day is day in month (1-31)
# $month is month in year (1-12)
# $year is four-digit year e.g., 1967
# $hours, $minutes and $seconds represent UTC time 
use Time::Local;
$time = timegm($seconds, $minutes, $hours, $day, $month-1, $year-1900);

As explained in the introduction, Epoch seconds cannot hold values before Fri Dec 13 20:45:52 1901 or after Tue Jan 19 03:14:07 2038. Don't convert such dates to Epoch seconds  - use a Date:: module from CPAN, and do your calculations with that instead.

See Also

The documentation for the standard Time::Local module (also in Chapter 7 of Programming Perl); convert in the other direction using Recipe 3.3

Previous: 3.1. Finding Today's DatePerl CookbookNext: 3.3. Converting Epoch Seconds to DMYHMS
3.1. Finding Today's DateBook Index3.3. Converting Epoch Seconds to DMYHMS