This subsection outlines the steps to follow when using SCCS:
Creating an SCCS file
Retrieving a file
Creating new releases and branches
admin -ich01 s.ch01
creates a new SCCS file and initializes it with the contents of
ch01, which will become
delta 1.1. The message, "No id
keywords (cm7)" appears if you do not specify any keywords.
In general, "id keywords" refer to variables
in the files that are replaced with appropriate values by get,
identifying the date and time of creation, the version retrieved,
etc. A listing of identification keywords occurs later in this section.
Once the s.ch01 file is created, the original file ch01 can be removed, since it can be easily regenerated with the get command.
get -e s.ch01
and the messages:
1.1 new delta 1.2 272 lines
may appear. This indicates that you are "getting"
and the resulting file has 272 lines of text. When the file is
reentered into the SCCS file s.ch01 with the delta command,
its changes are
The -e option indicates to SCCS that you intend to make more changes to the file and then reenter it into SCCS. Without this option, you will receive the file with read-only permissions. The -e option, besides releasing the file with read-write permissions, also creates a file p.ch01, which records information that will be used by SCCS when the file is returned.
The -r option to get tells SCCS what release and level number you want, but if no level is specified it defaults to the highest level available. With the command:
get -r3.2 ch01
delta 3.2 will be the release. However, the command:
get -r3 ch01
returns the highest-numbered level in release 3, for example 3.8. With the -r option omitted, get defaults to the highest release, highest level - in other words, the latest version.
When major changes are in store for a file, you may want to begin a new release of the file. You can do that by "getting" the file with the next highest release number. For example, if the latest release of a file is 3.2, and you want to start release 4, enter:
get -e -r4 ch01
You will receive the message:
3.2 new delta 4.1 53 lines
If you want to make a change to an older version of the same file, you can enter:
get -e -r2.2 ch01
and receive the message:
2.2 new delta 220.127.116.11 121 lines
You have now created a new branch from the trunk, stemming from version 2.2. Changes in this delta will not affect those in the trunk deltas, i.e., 2.3, 3.1, etc.
Once changes have been made to the SCCS file, return it to SCCS with the command:
You are prompted for comments on the changes. The delta command then does its own get and uses diff to compare the new version of the file with the most recent version. It then prints messages giving the new release number and the number of lines that were inserted, deleted, and unchanged.