Полезная информация

Perl Cookbook

Perl CookbookSearch this book
Previous: 7.19. Opening and Closing File Descriptors by NumberChapter 7
File Access
Next: 7.21. Program: netlock

7.20. Copying Filehandles


You want to make a copy of a filehandle.


To create an alias for a filehandle, say:


Use open with the & mode to create an independent copy of the file descriptor for the filehandle:

open(OUTCOPY, ">&STDOUT")   or die "Couldn't dup STDOUT: $!";
open(INCOPY,  "<&STDIN" )   or die "Couldn't dup STDIN : $!";

Use open with the &= mode to create an alias for that filehandle's file descriptor:

open(OUTALIAS, ">&=STDOUT") or die "Couldn't alias STDOUT: $!";
open(INALIAS,  "<&=STDIN")  or die "Couldn't alias STDIN : $!";
open(BYNUMBER, ">&=5")      or die "Couldn't alias file descriptor 5: $!";


If you create an alias for a filehandle with typeglobs, only one Perl I/O object is still being accessed. If you close one of these aliased filehandles, the I/O object is closed. Any subsequent attempt to use a copy of that filehandle will give you an error like "print on closed filehandle". When alternating access through the aliased filehandles, writes work as you'd expect because there's no duplicated stdio data structure to get out of sync.

If you create a copy of a file descriptor with open(COPY, ">&HANDLE"), you're really calling the dup (2) system call. You get two independent file descriptors whose file position, locks, and flags are shared, but which have independent stdio buffers. Closing one filehandle doesn't affect its copy. Simultaneously accessing the file through both filehandles is a recipe for disaster. Instead, this technique is normally used to save and restore STDOUT and STDERR:

# take copies of the file descriptors
open(OLDOUT, ">&STDOUT");
open(OLDERR, ">&STDERR");

# redirect stdout and stderr
open(STDOUT, "> /tmp/program.out")  or die "Can't redirect stdout: $!";
open(STDERR, ">&STDOUT")            or die "Can't dup stdout: $!";

# run the program

# close the redirected filehandles
close(STDOUT)                       or die "Can't close STDOUT: $!";
close(STDERR)                       or die "Can't close STDERR: $!";

# restore stdout and stderr
open(STDERR, ">&OLDERR")            or die "Can't restore stderr: $!";
open(STDOUT, ">&OLDOUT")            or die "Can't restore stdout: $!";

# avoid leaks by closing the independent copies
close(OLDOUT)                       or die "Can't close OLDOUT: $!";
close(OLDERR)                       or die "Can't close OLDERR: $!";

If you create an alias of a file descriptor using open(ALIAS, ">&=HANDLE"), you're really calling the fdopen (3) stdio function. You get a single file descriptor with two stdio buffers accessed through two filehandles. Closing one filehandle closes the file descriptor of any aliases, but not their filehandles  - if you tried to print to a filehandle whose alias had been closed, Perl wouldn't give a "print on closed filehandle warning" even though the print didn't succeed. In short, accessing the file through both filehandles is also a recipe for disaster. This is really used only to open a file descriptor by number. See Recipe 7.19 for more information on this.

See Also

The open function in perlfunc (1) and in Chapter 3 of Programming Perl; your system's dup (2) manpage

Previous: 7.19. Opening and Closing File Descriptors by NumberPerl CookbookNext: 7.21. Program: netlock
7.19. Opening and Closing File Descriptors by NumberBook Index7.21. Program: netlock